Siemens SINUMERIK 828D Commissioning Manual

Table of contents
1 Scope of delivery and requirements.............................................................................................................9
1.1 System overview......................................................................................................................9
1.2 Commissioning and service tools...........................................................................................11
1.3 Commissioning process.........................................................................................................13
1.3.1 Guide to the documentation...................................................................................................13
1.4 Starting up the control............................................................................................................16
1.5 To select the cylindrical/surface grinding technology, proceed as follows:............................20
1.6 Communication with the control.............................................................................................23
1.6.1 Communicating with the control via X130..............................................................................23
1.6.2 How to communicate with the control using the Programming Tool......................................25
1.6.3 How to communicate with the control via Access MyMachine...............................................26
2 Introduction and use of data classes..........................................................................................................29
2.1 Data classes in the NC...........................................................................................................30
2.2 Data classes in the PLC.........................................................................................................33
2.3 Data classes in the operating software..................................................................................34
3 Operating software settings........................................................................................................................37
3.1 Access levels.........................................................................................................................37
3.2 How to set and change the password....................................................................................39
3.3 How to set the date and time.................................................................................................40
3.4 Setting the operating software languages..............................................................................41
3.4.1 Available system languages and language extensions..........................................................41
3.4.2 This is how you delete a language extension........................................................................41
3.4.3 Entering Asian characters using the Input Method Editor......................................................42
3.4.4 This is how you enter the Chinese character ........................................................................44
3.4.5 This is how you enter Korean characters ..............................................................................45
3.5 Checking and entering licenses.............................................................................................47
3.5.1 How to enter a license key.....................................................................................................47
3.5.2 This is how you determine missing licenses/options..............................................................49
3.5.3 Definitions for license management.......................................................................................50
3.6 Configuring PLC alarms.........................................................................................................52
3.6.1 Structure of the PLC alarms...................................................................................................52
3.6.2 How to create PLC alarms.....................................................................................................54
3.6.3 Configuring the alarm log.......................................................................................................55
3.6.4 How to configure the log........................................................................................................56
3.7 Creating OEM-specific online help.........................................................................................59
3.7.1 Structure and syntax of the configuration file.........................................................................60
3.7.2 Structure and syntax of the help book....................................................................................61
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 3

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English