Note
If $P_PROG_EVENT==5 is used in the CYCPE_MA.SPF, no REPOSA may be programmed
as this is already present in the PROG_EVENT.SPF, otherwise an error occurs for SSL with
calculation.
7.3.3 Manufacturer cycle for tool change CUST_T and CUST_M6
Function
The two cycles are
used to track the T preparation (CUST_T) and the tool change (CUST_M6)
according to SERUPRO. In so doing, depending on the specific toolholder, the following is
output:
● Last programmed change
● Last programmed preparation
Sequence
The two cycles are called in the "SERUPRO-END-ASUB", which also provides the two transfer
parameters.
Parameter Meaning
_THnr Toolholder or master spindle number that was programmed for the change or the
preparation.
_MTHnr Number of the active toolholder or master spindle at the time of programming.
The cycles themselves do not contain and "machine logic". Pure data operations are performed.
The active toolholder or the master spindle is saved.
Using the transfer parameter, the situation at the time of the T or M6 programming is
determined. This situation is established, T and/or M06 output or a branch is made into the
manufacturer cycles. After the output of T and M06 or after returning from the manufacturer
cycles, the toolholder, saved at the beginning, is reactivated.
A change cycle can then only be called without any restriction, if the corresponding queries
such as program test, block search,...exist.
Configuring cycles
7.3 Manufacturer cycles
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 83
To Next Page
Loading...
Need help?
General
