7. Press the "Set time server" softkey.
If a connection to a time server exists, the settings will be synchronized
with the system immediately. After that, a cyclic check is made as to
whether the settings are effective. The "Set Date and Time" window re‐
mains open.
8. Confirm the entry with the "OK" softkey.
The time server settings and the current times are taken over from the
control.
Note
If the field "Use time server" is cleared again, the standard "UTC" time zone will apply again.
1.4 Changing the language
The operating software is available as standard in several languages.
Selecting a language
You can define the language selection mode using the following machine data.
MD9100 $MM_CHANGE_LANGUAGE_MODE Language selection mode
= 1 The user-interface language is specified via the "Language Selection" window (default val‐
ue).
1. Select the "Start-up" operating area.
2. Press the "Change language" softkey.
The "Language Selection" window opens. The language most recently
set is highlighted.
3. Switch the cursor to the required language.
4. Press the <INPUT> key.
- OR -
Press the "OK" softkey.
The operating software switches to the language selected.
General settings
1.4 Changing the language
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 19
To Next Page
Loading...
Need help?
General
