1.6 Communication with the control
Creating the connection
An Ethernet cable is needed to connect the control and PG/PC. The following Ethernet
interfaces are available on the control:
● Connection via X127 (behind the flap on the front):
Cable type: Crossed Ethernet cable
At interface X127, the control is preset as a DHCP server, delivering the IP
address192.168.215.1 for a direct connection (peer-to-peer connection).
● Connection via X130 (at the back):
Cable type: Uncrossed Ethernet cable
The
interface
X130
is
the connection to the company network. The IP address that the PG/
PC receives here as a DHCP client is determined by the DHCP server from the company
network or fixed IP address is entered manually.
1.6.1 Communicating with the control via X130
Connection to the company network
The NCU is connected to the company network via the Ethernet interface X130. The company
network is used, for example, to access the network drives.
In the "Diagnostics" operating area select the "Bus TCP/IP " → "TCP/IP Diagnostics" → "Details"
softkey with the menu forward key in order to set the parameters for the communication via
X130.
Scope of delivery and requirements
1.6 Communication with the control
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 23
To Next Page
Loading...
Need help?
General
