Siemens SINUMERIK 828D Commissioning Manual

COMPCAD
G645
FIFOCTRL
UPATH
;FFWON
Dependent on the machining type:
DYNNORM
DYNFINISH
DYNSEMIFIN
DYNROUGH
7.8.3 Top Surface: CYCLE832 extension
Function
Besides Advanced Surface, the High Speed Settings (CYCLE832) function also offers the
extension Top Surface.
You can use Top Surface to improve the quality of free-form surfaces.
If set actively, the continuous-path control is optimized within contour tolerances. The
CYCLE832 call also contains the smoothing parameter.
Software option
To use this function, you need the software option:
"Top Surface"
Figure 7-18 Roughing, semi-finishing, or finishing with active smoothing
Tolerance
The tolerance value for Top Surface is transferred as a contour tolerance to the NC with
command CTOL.
Configuring cycles
7.8 High Speed Cutting (HSC)
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 169

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English