</context
</TS>
9.2.23 Reason for the tool change when reactivating
Precondition
Software option
You require the "MC Information System TDI Statistic" option for this function
Function
When
reactivating a tool,
you have the option of specifying the reason for the tool change, e.g.
to use this information for statistical purposes. The "Reason for Tool Change" selection window
is opened after pressing the "Reactivate" softkey. In a checkbox, you can select the reason
for the tool change. The tool change is entered in a tool parameter to be configured or in a
local variable of the SlCap service.
Tool change reasons
You can adapt or expand the tool change reasons as required. The operating software provides
the following pre-defined texts for the configuration:
Text identifier Text
TM_DGL_DESIRED_PIECES_ELAPSED Unit quantity setpoint (desired pieces) elapsed
TM_DGL_TOOL_BREAKAGE Tool breakage
TM_DGL_CUTTING_EDGE_DAMAGE Cutting edge damage
TM_DGL_PREMATURE_WEAR Premature wear
TM_DGL_TYPE_REEQUIPPING Type reequipping
TM_DGL_TOOL_TRIAL Tool trial
TM_DGL_PREVENTIVE_CHANGE Preventive change
<TOOLCHANGEREASON> tag
You configure the function in the <TOOLCHANGEREASON> tag:
Parameter Designation
Enabled True - "Reason for tool change" selection window is displayed when
reactivating.
False - default value, selection window is not displayed.
OnlyOneReasonAllowed It is only permissible to select one tool change reason.
UseCapLocalParameter The reason for the tool change is entered into a local variable of the
SlCap service.
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 281
To Next Page
Loading...
Need help?
General
