Siemens SINUMERIK 828D Commissioning Manual

9.2.2.5 Magazine location parameter identifiers
For the magazine location parameters, the following identifiers are used in the configuration
file:
Identifier Parameter or property System variable
*)
MagPlaceKind Location kind $TC_MPP1
MagPlaceType Location type $TC_MPP2
MagPlaceTypeIdent Location type as text $TC_MPP2
MagPlaceTNo Tool number of the tool in this location $TC_MPP6
MagPlaceWatchNeighbour Consider adjacent location $TC_MPP3
MagPlaceStateLocked Magazine location locked $TC_MPP4, Bit0
MagPlaceStateEmpty Magazine location free $TC_MPP4, Bit1
MagPlaceStateResInterMag
Reserved for tool in buffer $TC_MPP4, Bit2
MagPlaceStateResLoadTool Reserved for tool to be loaded $TC_MPP4, Bit3
MagPlaceStateOccupiedLeft Magazine location occupied, left half location $TC_MPP4, Bit4
MagPlaceStateOccupiedRight Magazine location occupied, right half loca‐
tion
$TC_MPP4, Bit5
MagPlaceStateOccupiedUpper Magazine location occupied, upper half loca‐
tion
$TC_MPP4, Bit6
MagPlaceStateOccupiedDown Magazine location occupied, lower half loca‐
tion
$TC_MPP4, Bit7
MagPlaceStateReservedLeft Magazine location reserved, left half location $TC_MPP4, Bit8
MagPlaceStateReservedRight Magazine location reserved, right half location $TC_MPP4, Bit9
MagPlaceStateReservedUpper Magazine location reserved, upper half loca‐
tion
$TC_MPP4, Bit10
MagPlaceStateReservedDown Magazine location reserved, lower half loca‐
tion
$TC_MPP4, Bit11
MagPlaceMagazineNo Magazine number -
MagPlaceTypeIdx Type index $TC_MPP5
MagPlaceWearGroup Wear group number $TC_MPP5
MagPlaceAdaptNo Adapter number $TC_MPP7
MagPlaceNo Magazine location number -
MagNoMagPlaceNo Magazine number/Magazine location number -
MagPlaceUser_1, ... MagPla‐
ceUser_10
OEM magazine location parameters 1 to 10 $TC_MPPC1, ...
$TC_MPPC10
MagPlaceAppl_1, ... MagPla‐
ceAppl_10
Siemens magazine location parameters 1 to
10
$TC_MPPCS1, ...
$TC_MPPCS10
*)
Parameter corresponds to the system variable or the system variable is the basis for this
parameter.
Tool management
9.2 Configuring the user interface
SINUMERIK Operate
246 Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English