See also
Load Grid (LG) (Page 137
)
7.3.3 Focus control in the table (cell)
Description
The Row and Col properties can be used to set and calculate the focus within a table:
● Identifier.Row
● Identifier.Col
Programming
Each cell in a table has the Val and Vld properties.
In order to read and write cell properties, a line and column index must be specified in addition
to the variable identifiers from the definition list.
Syntax: Identifier[Line index, column index].val or
Identifier[Line index, column index]
Description: Val properties
Syntax: Identifier[Line index, column index].vld
Description: Vld properties
Example
Var1[2,3].val=1.203
If the line and column indices are not specified, the indices of the focused cell apply. This
corresponds to:
Var1.Row =2
Var1.Col=3
Var1.val=1.203
Graphic and logic elements
7.3 Table description (grid)
SINUMERIK Integrate Run MyScreens
174 Programming Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
