Parameterizing machine data
4
4.1 Classification of machine data
Authorization for machine data
At least the Manufacturer password is necessary to enter or change machine data.
WARNING
Lethal danger and danger for machines
Changes in the machine data have a considerable influence on the machine.
Incorrect
configuration
of
the
parameters can endanger human life and cause damage to the
machine.
Classification of machine data
The machine data is divided into the following areas:
● General machine data ($MN )
● Channel-specific machine data ($MC )
● Axis-specific machine data ($MA )
●
Display machine data ($MM )
● General setting data ($SN )
● Channel-specific setting data ($SC )
● Axis-specific setting data ($SA )
● SINAMICS machine data (Control Unit and drive machine data):
r0001 ... r9999 (read-only)
r0001 ... r9999 (read/write)
At SINUMERIK Operate in the operating area "Startup", there is a list image for each of these
areas:
Note
Machine data for the
technologies is already set up in such a way that an adjustment of machine
data is only necessary in exceptional cases.
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 77
To Next Page
Loading...
Need help?
General
