<td colspan="6">This MD is used to enter the names of the geometry axes
separately for each channel.<br />
<tr>
<td>-</td>
<td colspan="5"> </td>
</tr>
<tr>
<td width="16*">System</td>
<td width="16*">Dimension</td>
<td width="16*">Default value</td>
<td width="16*">Minimum value</td>
<td width="16*">Maximum value</td>
<td width="16*">Protection</td>
</tr>
<tr>
<td>-</td>
<td>-</td>
<td>0</td>
<td>0</td>
<td>2</td>
<td>7/3</td>
</tr>
</table>
<p></p>
</body>
</html>
2.2.5 Saving the online help in the OEM directory
Storage path
Save the HTML file sinumerik_md_1.html for the English help under the following path:
[System oem directory]
/hlp/eng
You must create a folder for additional languages (e.g. chs, deu, esp, fra, ita …).
A list of language codes is provided in the Appendix.
2.2.6 Copying easyscreen.ini into the OEM directory
Storage path
Copy the file easyscreen.ini from the directory
[System SIEMENS directory]
/cfg
to the directory
[System oem directory]
/cfg
Getting Started
2.2 Example
SINUMERIK Integrate Run MyScreens
Programming Manual, 10/2015, 6FC5397-3DP40-5BA3 23
To Next Page
Loading...
Need help?
General
