VSK7 Positions OEM Plunge turn‐
ing residual
material
OEM OEM Spigot res.
mat.
-- OEM
VSK8 Repeat posi‐
tion.
-- >> << Contour
milling
<< >> <<
ShopTurn start softkeys:
Drilling Turning Contour turning Milling Miscellaneous
HSK2 HSK3 HSK4 HSK5 HSK6 HSK10
VSK1 Drilling
centered
Stock re‐
moval
New contour -- Face mill‐
ing
New con‐
tour
Settings High
speed set‐
tings
Tool
VSK2 Centering Groove Stock removal -- Pocket Path Swivel
plane
Parallel
axes
Straight line
VSK3 Drilling
reaming
Undercut Stock remov‐
al residual
material
-- Multi-edge
spigot
Predrilling Swivel tool Repeat
progr.
Circle center
point
VSK4 Deep-
hole drill‐
ing
Thread Grooving -- Groove Pocket Counter‐
spindle
-- Circle radius
VSK5 Thread Parting Grooving re‐
sidual materi‐
al
-- Thread mill‐
ing
Pocket
res. mat.
Transfor‐
mations
-- Polar
VSK6 OEM -- Plunge-turn‐
ing
-- Engraving Spigot Subpro‐
gram
-- Approach/re‐
tract
VSK7 Positions OEM Plunge turn‐
ing residual
material
OEM OEM Spigot
res. mat.
-- OEM --
VSK8 Repeat
position.
-- >> << Contour
milling
<< >> << --
See also
Defining the start softkey (Page 28
)
A.1.2 List of start softkeys for milling
Program operating area when milling
HSK1 HSK2 HSK3 HSK4 HSK5 HSK6 HSK7 HSK8
Edit Drilling Milling Contour mill‐
ing
Turning
(only for G
code)
Miscellane‐
ous
Simulation NC select
Reference lists
A.1 Lists of start softkeys
SINUMERIK Integrate Run MyScreens
200 Programming Manual, 10/2015, 6FC5397-3DP40-5BA3
To Next Page
Loading...
Need help?
General
