9.3 NC ↔ PLC user interface
Overview
The
tool
management
receives
tasks for preparing and carrying out a tool change (T command,
M06), a tool movement (MVTOOL) or magazine positioning (POSM) from the part program or
from SINUMERIK Operate. From these tasks the TM defines the location change needed for
the tool and assigns this to the PLC.
The user interface provides separate data blocks for loading, unloading, relocating and
magazine positioning on the one hand and tool change on the other hand.
-REVWDWXV
'%[['%[[
'%%
8VHULQWHUIDFH
1&3/&LQWHUIDFH
3/&XVHUSURJUDP
&RQWURORIWKHPDFKLQHIXQFWLRQVDFNQRZOHG
JPHQWRIWKHWUDQVIHUVWHSV
8VHU
6\VWHP
3/&ILUPZDUH
7RROPDQDJHPHQW
3/&
1&
)HHGEDFNVLJQDO
'%[['%[[
'%%'%%
$FNQRZOHGJPHQW
'%[['%[[
'%;'%;
-RE
'%[['%[[
'%;'%%
Figure 9-1 Interfaces of the tool management
Tool management
9.3 NC ↔ PLC user interface
CNC commissioning
Commissioning Manual, 10/2015, 6FC5397-3DP40-5BA3 263
To Next Page
Loading...
Need help?
General
