Changes
MagneMover LITE User Manual 27
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
• Updated all trademark and copyright information and moved to the back cover.
• Updated the titles and part numbers for all referenced manuals.
• Updated all references for contacting ICT Customer Support to referencing Rockwell
Automation Support on page 486, TechConnect
℠
(rockwellautomation.custhelp.com),
and the Literature Library and Product Configurator.
• Updated the appearance of the safety notices to match Rockwell Automation stan-
dards.
• Updated all graphics to current component versions.
• Updated the graphic used for pinch/crush hazards.
•In Chapter 1, Introduction, updated the Transport System Components Overview.
Updated the Transport System Software Overview.
•In Chapter 2, Safety Guidelines, changed the title from Safety to Safety Guidelines.
Updated the descriptions of the hazard symbols. Updated the Recycling and Disposal
Information.
•In Chapter 3, Design Guidelines, updated the Transport System Layout section.
Updated the Transport System Design section to include an updated description of
motor gaps and updated the information about Electrical Wiring to include motors
using Ethernet communication. Added additional details to the System Stands informa-
tion.
•In Chapter 4, Specifications and Site Requirements, updated the exposed materials
identification in the Mechanical Specifications. Updated the Communication section
to include the Ethernet motors and remove the node controllers. Added Derating at
High Altitude for the air-cooled motors.
•In Chapter 5, Installation, updated Connecting Motors and Electronics to include the
Ethernet motors. Updated Facilities Connections. Updated Software Overview and
System Power-up.
•In Chapter 6, Operation, updated Simulated Operation Differences. Updated Preci-
sion Locator Operation to include Operation Using Cylinder Position Sensors.
•In Chapter 7, Maintenance, updated the Puck Cleaning procedures to cover both glide
and wheeled pucks. Updated the Clean or Replace the MM LITE Power Supply Air
Filter procedure. Updated the Troubleshooting section. Updated the Contact Support
section. Updated the precision rail vehicle maintenance procedures.
•In the Appendix, updated the Transport System Limits.
• Updated the Glossary and Index.
Removed the following:
• Removed all references to the MagneMover LITE G3 motors.
• Removed all references to ICT Customer Support, these now refer to the Rockwell
Automation Technical Support Center and TechConnect.
• Removed all detailed information for the node controllers and Ethernet switch. This
information is now in the Node Controller Hardware User Manual, MMI-UM013.
• Removed all references to power regeneration during vehicle deceleration.
To Next Page
Loading...
Need help?
General
