Rockwell Automation MagneMotion MagneMover LITE User Manual

Maintenance
Repair
MagneMover LITE User Manual 435
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
1. Stop all motion on the path where the vehicle having a lubricator replaced or installed
is located.
2. If the lubricator under the precision rail vehicle is being replaced, remove the existing
lubricator.
3. Locate the new lubricator under the precision rail vehicle between either the eccentric
bearings or concentric bearings using the two corresponding screw holes as shown in
Figure 7-41. Make sure that the felt end of the lubricator is facing toward the rail loca-
tion. Secure the lubricator by inserting two M3 x 8 mm screws and tighten finger-tight
only. Do not overtighten the screws or they can strip the holes on the lubricators.
Figure 7-41: Installing or Removing a Precision Rail Lubricator
4. Apply lubricant to the felt applicator, see Refill the Lubricator on Precision Rail Vehi-
cles on page 363. Do not overfill the reservoir.
5. Return the MM LITE transport system to normal operation.
Mounting holes at
Eccentric Bearings
Mounting holes at
Concentric Bearings

Rockwell Automation MagneMotion MagneMover LITE Specifications

General

Brand	Rockwell Automation
Model	MagneMotion MagneMover LITE
Category	Accessories
Language	English