Maintenance
Repair
432 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
5. Tilt the vehicle at an angle, with the eccentric bearings positioned down and the mag-
net arrays upward, as shown in Figure 7-37.
Figure 7-37: Precision Rail Vehicle Eccentric Bearings
6. Touch the inside edges of the eccentric bearings to the outside edge of the rail, then
slowly roll the magnet side of the vehicle onto the rail to bring the concentric bearings
and magnet arrays to a horizontal position.
Figure 7-38: Install Precision Rail Vehicle on Rail
7. To adjust both eccentric bearings, see Adjust Vehicle Bearings on page 367.
8. Reattach the lubricator to bottom of the vehicle. See Install/Replace the Lubricators
on Precision Rail Vehicles on page 433.
9. Return the MM LITE transport system to normal operation.
Eccentric
Bearing
Bearing Nut
Motor Side of Vehicle
To Next Page
Loading...
Need help?
General
