Rockwell Automation MagneMotion MagneMover LITE User Manual

Maintenance
Preventive Maintenance
MagneMover LITE User Manual 351
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Procedure
1. Remove the glide puck from the MagneMover LITE transport system (see Replace
Pucks on page 399).
2. Wear gloves and clean internal puck wear surfaces with clean cotton tipped swabs
slightly dampened with Isopropyl alcohol. Run the swabs between the top and center
plates with a back-and-forth motion in the direction of travel (see Figure 7-1).
NOTE: Squeezing the swab does not cause any alcohol to drip.
Figure 7-1: Glide Puck Cleaning
3. Wear gloves and clean external puck surfaces with a clean microfiber cloth slightly
dampened with Isopropyl alcohol. Run the cloth over the surfaces in the direction of
travel (see Figure 7-1).
NOTE: Squeezing the cloth does not cause any alcohol to drip.
4. Wear gloves and dry all cleaned puck surfaces with a clean, dry, cotton tipped swab,
and a clean dry microfiber cloth.
5. Replace the puck on the MM LITE transport system (see Replace Pucks on page 399).
Internal Wear
External Wear
Surfaces
Surfaces

Rockwell Automation MagneMotion MagneMover LITE Specifications

General

Brand	Rockwell Automation
Model	MagneMotion MagneMover LITE
Category	Accessories
Language	English