Installation
Transport System Installation
MagneMover LITE User Manual 277
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Puck Installation
Pucks (the vehicle used to transport material through the MagneMover LITE transport sys-
tem) can easily be added or removed as needed once the MM LITE transport system is
installed.
NOTE: MagneMotion recommends installing all pucks before completing the motor instal-
lation on a closed-loop system by sliding them onto the transport system at the end
of an installed motor and then sliding them out of the way.
If the transport system has been fully assembled and there is no section of the system that is
configured for loading/unloading pucks, see Replace Pucks on page 399 for the preferred
method to add or remove pucks. See Replace Precision Rail Vehicles on page 428 for the pre-
ferred method to add or remove vehicles on transport systems with precision rails.
To Next Page
Loading...
Need help?
General
