Installation
Option Installation
298 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Install the Precision Locators on the Stands
The precision locators are installed on the stands before installing the stands to provide ease of
assembly. The precision locators can be removed or installed on the stands once the stand is
installed in the transport system, however it is more difficult to access the mounting screws
for the locator.
1. Install the pneumatic fittings on the precision locator cylinder using Teflon
™
tape.
2. Install each precision locator on the stand and secure using four M6 x 25 mm screws
then tighten to 4.5 N•m [40 in•lb] with a 5 mm Hex wrench.
Install the Precision Locator Assemblies
The stands are installed loosely to allow final positioning with the equipment accessing the
pallet.
1. Remove the back plate from the stand by removing the M6 x 12 mm screws securing it
and store the screws for reuse.
2. Install the precision locator stand.
Mounting the Standard Precision Locator Stand (see Figure 5-43)
A. Install one M8 T-nut in the top channel of the beam at the approximate location
for each precision locator stand rib. T-nuts must be inserted so that the spring
steel tabs are facing toward the beam, then rotated clockwise into place).
B. Position the locator stand on the beam and aligned to the T-nuts, install an M8
x 30 mm bolt and M8 split lock washer for each rib and finger-tighten.
Mounting the Alternate Precision Locator Stand (see Figure 5-44)
A. Position the locator stand onto the locating pins on the custom fixturing.
B. Install an M8 x 30 mm bolt and M8 split lock washer for each rib and fin-
ger-tighten.
Install the Motors
Once the motors are installed and properly positioned, the precision locator can be secured in
its final position.
1. Install the adjustable motor mounts on the motor (see Installing Motor Mounts on
Motors and Switches).
2. Install the motor (see Mounting Motors and Switches on page 256 and Align and
Secure Motors and Switches on page 258).
The Loctite must cure for 2 hours at 22° C [72° F] before using the transport system.
To Next Page
Loading...
Need help?
General
