Machine mode of operation | Program run submode
4
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
143
Comparing tool lists
While a program is being loaded, the control compares the current
turret assignment list with the tool list of the program. If tools are
used in the program that are not in the current turret list or are
located in another pocket, an error message is displayed.
After the error message has been confirmed, the program-
dependent tool list is shown for checking.
You can overwrite the current turret assignment list with the
Load tool soft key. If you press the Cancel soft key, the program
cannot be started. The tool list of the program must match the
current turret assignment list.
NOTICE
Danger of collision!
If you press the Load tool soft key, the current turret assignment
list will be overwritten completely and irreversibly with the tool
list of the program. The lists will then not be compared again
for whether they match. There is a danger of collision during
subsequent machining operations!
Check the turret assignment list manually after it has been
overwritten
This function is also available on machines with a tool
magazine. The control uses the magazine list instead of
the turret list.
To Next Page
Loading...
Need help?
General
