Organization mode of operation | Transfer submode
9
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
669
Importing NC programs from predecessor controls
The program formats of the predecessor controls MANUALplus
4110 and CNC PILOT 4290 differ from the format of the
MANUALplus 620 and the CNC PILOT 640. However, you can
use the program converter to adapt programs of the predecessor
control to the new control. This converter is a component of your
control. The converter completes the required adaptations as
automatically as possible.
Overview of convertible NC programs:
MANUALplus 4110
Cycle programs
ICP contour descriptions
DIN programs
CNC PILOT 4290: DIN-PLUS programs
TURN PLUS programs of the CNC PILOT 4290 can not be
converted.
To Next Page
Loading...
Need help?
General
