ICP programming | C-axis and Y-axis machining in smart.Turn mode of operation
6
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
471
6.11 C-axis and Y-axis machining in
smart.Turn mode of operation
In smart.Turn mode of operation, ICP supports the definition of
milling contours and holes as well as the creation of milling and
drilling patterns that are machined with the aid of the C axis or Y
axis.
Before you use ICP to describe a milling contour or a hole, select
the plane:
C axis
Frontface (XC plane)
Surface (ZC plane)
Y axis
Frontface (XY plane)
Surface (YZ plane)
A hole can contain the following elements:
Centering
Core hole
Cavity
Thread
The parameters are evaluated for drilling or tapping.
You can arrange holes in linear or circular patterns.
Milling contours: The control is familiar with standard figures (full
circle, polygon, slot, etc.). You can define these figures with a few
parameters. Complex contours are described with lines and circular
arcs.
You can arrange standard figures in linear or circular patterns.
To Next Page
Loading...
Need help?
General
