Teach-in | Milling cycles
5
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
395
Engraving, axial and radial
Engraving, axial and radial
The control can realize the characters listed in the following table.
The text to be engraved is entered as a character string. Diacritics
and special characters that you cannot enter in the editor can
be defined, character by character, in NF. If text is defined in ID
and a character is defined in NF, the text is engraved before the
character.
The engraving cycles are not available in Machine mode.
To Next Page
Loading...
Need help?
General
