Graphic simulation | Zooming function in simulation
7
544
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
7.4 Zooming function in simulation
Adjusting the displayed detail
Soft key Meaning
Press this soft key to activate the
zoom function
With the zoom menu, you can modify the detail displayed in the
simulation window. As an alternative to the soft keys, you can
use the arrow keys and the PgDn and PgUp keys to change the
displayed detail.
For cycle programs, and when a program is started for the first
time in Simulation submode, the control automatically selects the
detail. When you simulate the same smart.Turn program again in
the Simulation submode, the last selected detail is used.
In the multiple window view, the zoom function is effective for the
window marked by a green frame.
Soft keys in the zoom menu
Delete all traverse paths drawn so far
If contour follow-up is active, the
workpiece blank is updated and newly
drawn
Close the zoom menu
Extend the displayed detail directly (zoom –)
Switch back to the standard screen detail
and close the zoom menu
Return to the last detail selected
Load the area selected by the red frame as
the new detail and close the zoom menu
Close the zoom menu without changing the
selected detail
To Next Page
Loading...
Need help?
General
