Basics of operation | DataPilot programming station
2
82
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
2.8 DataPilot programming station
Application
Intended for use with the CNC PILOT 640 and MANUALplus
620 controls, respectively, the PC programs DataPilot CP 640 and
DataPilot MP 620 enable you to create NC programs on a PC, test
them before execution, transfer them to the control, and archive
them after production is concluded.
DataPilot can be used for shop-floor programming as well as for
office and off-location program creation and testing. Its practicality
and wide range of functions also make DataPilot ideal for training
purposes.
Operation
DataPilot is operated through function keys and numerical keys of
the PC keyboard.
For more information about installation and operation,
please refer to the DataPilot installation and operating
instructions.
To Next Page
Loading...
Need help?
General
