Basics of operation | Operation and data input
2
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
63
2.3 Operation and data input
Modes of operation
The active mode of operation is highlighted in the operating-mode
tab. The control differentiates between the following operating
modes:
Machine—with the submodes:
Teach-in
Program run
ICP editor
Reference
Simulation
smart.Turn—with the submodes:
ICP editor
Automatic working plan generation AWG
Simulation
Tool editor—with the submodes
Technology editor
Organization—with the submodes
Machine par. programming
Transfer
You can use the operating mode keys to switch between the
modes. The selected submode and the current menu position
remain when the operating mode is switched.
If you press the operating mode key in a submode, the control
switches back to the main level of the mode.
In some situations, it is not possible to switch modes
(e.g. in Tool editor operating mode).
In such cases, you need to terminate the editing
process or close the dialog before switching the
operating mode.
To Next Page
Loading...
Need help?
General
