Machine mode of operation | Program run submode
4
150
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Automatic job
Automatic job
In Program run submode, the control can execute several main
programs in succession without you needing to reselect and start
these programs. For this purpose, create a program list (automatic
job) in smart.Turn, operating mode that is then processed in
Program run submode.
Specify a quantity for each main program in the list that defines
how often this program is carried out before the next NC program
is started. With job selection, you can specify an NC program from
which the job is to be processed.
If the automatic job was interrupted under the following conditions,
the control will save the interrupted program and the number of
pieces already machined:
NC stop
Emergency stop
Power failure
Programming notes:
Automatic jobs (*.job) can only be created in the
default directory. The NC programs used for the job,
however, can be stored in any project directories.
If the program list should be processed without
intervention, the listed main programs must be
exited with M99.
M30 stops the automatic job. With the NC start key,
you can resume the automatic job.
Selecting a job:
Select the Prog menu item
Select the Job selection menu item
Select Automatic job
Press the Open soft key
Select the start program with the cursor if
necessary
Confirm with the Take over job soft key
To Next Page
Loading...
Need help?
General
