Organization mode of operation | Transfer submode
9
644
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
9.3 Transfer submode
The Transfer submode is used for data backup and data exchange
via networks or USB devices. When we speak of files in the
following, we mean programs, parameters and tool data.
The following file types can be transferred:
Programs (cycle programs, smart.Turn programs, DIN main
programs and DIN subprograms, ICP contour descriptions)
Parameter
Tool data
Screenshots (taken with the PRT SC key) can be
transferred from the Service area.
Data backup
HEIDENHAIN recommends backing up the tool data and programs
created on the control on an external device at regular intervals.
You should also back up the parameters. Since the parameters are
not changed very often, however, you only need to back up the
parameters from time to time, as required.
Data exchange with TNCremo
HEIDENHAIN offers the PC program TNCremo to complement the
control. This program enables you to access the control data from a
PC.
External access
The machine tool builder can configure the external
access options. Refer to your machine manual.
The External access soft key can be used to permit or restrict
access through the LSV2 interface.
Permitting external access:
Select the Organization operating mode
Set the External access soft key to ON
The control will then permit data access through
the LSV2 interface
Restricting external access:
Select the Organization operating mode
Set the External access soft key to OFF
The control will then disable access through the
LSV2 interface
To Next Page
Loading...
Need help?
General
