Organization mode of operation | Parameters
9
606
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
9.2 Parameters
Parameter editor
The parameter values are entered in the configuration editor.
Each parameter object has a name, e.g. CfgDisplayLanguage
(101300) that gives information about the parameters it contains.
Each object has a key for unique identification.
The icon at the beginning of each line in the parameter tree shows
additional information about this line. The icons have the following
meanings.
Icon Meaning
Branch exists but is closed
Branch is open
Empty object, cannot be opened
Initialized machine parameter
Uninitialized (optional) machine parameter
Can be read but not edited
Can neither be read nor edited
Machine parameters (user parameters)
Machine parameters are used to adapt the behavior of the control.
Machine parameters that are preset for the usual "daily operations"
are organized as user parameters.
Refer to your machine manual.
Your machine tool builder can make additional machine
parameters available as user parameters.
To Next Page
Loading...
Need help?
General
