Introduction and fundamentals | Configuration
1
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
43
1.2 Configuration
In the standard version, the control is equipped with the axes X and
Z and a main spindle. Optionally, a C axis, a Y axis, and a driven tool
can be configured.
Slide position
The machine tool builder configures the control depending on the
slide position.
Z axis horizontal with tool slide behind the workpiece
Z axis horizontal with tool slide in front of the workpiece
Z axis vertical with tool slide to the right of the workpiece
The menu symbols, help graphics and graphic representations
during ICP and simulation consider the slide position.
The representations in this User's Manual assume a lathe with a
tool carrier centered behind the workpiece.
Tool carrier systems
The control supports the following systems as tool carriers:
Multifix holder with one tool mount
Turret with n tool mounts
Turret with n tool mounts and one multifix holder with one tool
mount. Here it is possible for one of the two tool carriers to
be arranged mirrored on the workpiece side opposite from the
standard tool carrier
Two multifix holders, each with one tool mount. The tool
carriers are arranged opposite to each other. One of them is
then mirrored.
Magazine with n tool mounts and one tool carrier in the working
space with one tool mount
To Next Page
Loading...
Need help?
General
