ICP programming | Contour elements – front face
6
460
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Basic elements of face
Starting point of face contour
Enter the coordinates for the starting point and target point in the
first contour element of the contour. Entering the starting point is
only possible in the first contour element. In subsequent contour
elements, the starting point results from the previous contour
element in each case.
Defining the starting point:
Press the Contour menu item
Alternative: Press the Insert element soft key
Define the starting point
Parameters for defining the starting point:
XKS, YKS: Starting point of contour
CS: Starting point of contour (polar angle)
PS: Starting point of contour (polar; radius)
HC: Milling/drilling attribute
1: Contour milling
2: Pocket milling
3: Area milling
4: Deburring
5: Engraving
6: Contour + deburring
7: Pocket + deburring
14: Do not machine
QF: Cutter position
0: On the contour
1: Inside / left
2: Outside / right
HF: Direction
0: Up-cut
1: Climb
DF: Milling diameter
WF: Angle of chamfer
BR: Chamfer width
RB: Return plane
ICP generates a G100 in smart.Turn mode of operation.
To Next Page
Loading...
Need help?
General
