Teach-in | Thread and undercut cycles
5
316
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
Last cut
After the cycle is finished, the control presents the Last cut option.
In this way you can enter a tool compensation value and repeat the
last thread cut.
Sequence of the Last cut function:
Initial situation: The thread cut cycle has been run, and the thread
depth is not correct.
Perform the tool compensation
Press the Last cut soft key
Press the NC start key
Check the thread
The tool compensation and the Last cut can be
repeated as often as necessary until the thread is
correct.
To Next Page
Loading...
Need help?
General
