USB
G338/G339 8 SM
1.4.2 REMARKS ABOUT USB
• The machine does not print reports specifically for USB.
• Only one host computer is allowed for the USB connection.
• After starting a job using USB, do not switch the printer off until the job has been
completed. When a user cancels a print job, if data transmitted to the printer has
not been printed at the time of cancellation, the job will continue to print up to the
page where the print job was cancelled
• When the controller board is replaced, the host computer will recognize the
machine as a different device.
Related SP Mode
“USB Settings” in the printer engine service mode. Data rates can be adjusted to
full speed fixed (12 Mbps). This switch may be used for troubleshooting if there is a
data transfer error using the high speed mode (480Mbps).
Data rates can also be adjusted using the UP mode “USB Setting” in the Host
Interface in the System menu. This mode can be accessed only when the “Enter”,
“Escape”, then “Menu” keys are pressed to enter the UP mode.
To Next Page
Loading...
Need help?
General
