SERVICE PROGRAM MODE
B064 Series/B140 Series/G126 5-2 SM
To Switch to the Copy Window for Test Printing (B140 Series/B064 Series)
1. In the SP mode display, press Copy Window to switch to the copy operation
screen when you need to select paper for a test print.
2. Use the copy window (copier mode) to select the appropriate settings (paper
size, etc.) for the test print.
3. Press Start to execute the test print.
4. Press SP Mode (highlighted) to return to the SP mode screen and repeat from
step 1.
Using the SP Mode
SP command numbers can be entered directly (if you know the entire number) or
the command can be selected from the menus.
Direct Entry (B140 Series/B064 Series)
SP5831 (Initial Setting Clear) an executable SP that initializes the User Tools
settings, can be executed immediately by just entering the numbers.
1. Press .
2. Press Enter .
3. Press “Execute” on the touch panel.
If you know all seven digits of the SP code, enter the seven numbers and press
“Execute”.
However, if you do not know all the numbers, enter only the first four numbers of
the seven-digit SP and press Enter . The display goes immediately to the first
SP of that group. Then you can use the buttons to browse to the desired selection.
Command Select Entry (G126)
SP modes must be selected from the displayed menu. Use “Up/Down” arrow on
the operation panel to locate the necessary SP mode. Then, press “Enter” to select
that SP mode.
Press “Escape” to exit that Sp mode.
Rev. 05/2005
To Next Page
Loading...
Need help?
General
