SD CARD APPLICATION MOVE
B064 Series/B140 Series/G126 5-28 SM
Move Exec
Do this procedure to move an application from one SD card to another.
1. Turn the main switch OFF.
2. Put the destination SD card in SD Card Slot 1.
3. Put the source SD card into SD Card Slot 3. This SD card holds the application
program that you want to copy to the destination SD card in Slot 1.
4. Turn the main switch ON.
5. Go into the SP mode.
6. Do SP5873-001 “Move Exec.”
7. Obey the messages on the operation panel to complete the procedure.
8. Turn the main switch OFF.
9. Remove the SD card from SD Card Slot 3.
10. Turn the main switch ON.
11. Check that the application programs combined on the SD card in Slot 1 operate
correctly.
NOTE: Once “Move Exec” is executed, continue to Section 1-17-9, “Data
Overwrite Security”, Step 5. See RB140015 for explanation if necessary.
Undo Exec
Do this procedure if you moved an option from the original SD card to another card
by mistake, and you want to restore it to the original SD card.
1. Turn the main switch OFF.
2. Put the SD cards into the SD card slots as follows:
Slot 3
: The original option SD card.
NOTE: This card is now blank, because the option software was moved.
Slot 1: The SD card that the option software was moved to.
NOTE: This card now contains the option software.
3. Turn the main switch ON.
4. Do SP5873-002 (Undo Exec).
5. Follow the instructions of the operation panel messages.
6. Turn the main switch OFF.
7. Remove the SD card from Slot 1.
8. Remove the option SD card from Slot 3, and then put it in Slot 1.
9. Turn the main switch ON.
10. Do SP5990-005 (Loading Program) and make sure the program runs correctly.
11. Turn the main switch OFF.
12. Remove the option SD card from Slot 1.
⇒
Rev. 05/2005
To Next Page
Loading...
Need help?
General
