Ricoh 4051 Service Manual

SOFTWARE UPDATE
B064 Series/B140 Series/G126 5-22 SM
GW Controller/BCU Update
1. Switch the main power switch off.
2. Disconnect the ADF plug, remove the rear upper cover ( x 2), then remove
the IC card slot cover ( x 1).
3. With it’s a side facing up, insert the IC card into the slot.
4. Switch the machine on.
5. Wait for the update screen to open.
NOTE:
1) In the ROM number displays, the first line is the software number and
the second line is the version number.
2) The left column displays the current software and version numbers of
the software in the machine, and the column on the right displays the
same information for the data on the IC card.
6. Press the appropriate item on the touch-panel.
• For the RA2K controller, press System (1) and Copy (2) on the touch-panel,
or you can press  or  on the operation panel.
• For the BCU, press Engine (3) on the touch-panel, or you can press  on
the operation panel.
• To update all, press two buttons simultaneously.
7. To start the installation, press Update (#) on the touch panel, or press  on
the operation panel.
8. The installation screen opens. As the installation progresses, the dashes on the
display are replaced by asterisks (****----)
9. When “Power Off/On” is displayed, switch the machine off and remove the IC
card.
PC Card -> NEW Page 01
Exit (0)
ROM: B0655102
ROM: 0.4.6
ROM: B0655102
ROM: 0. 4. 6
ROM: B0655120
ROM: 2.19
NEW: B0655102
NEW: 0.4.6
NEW: B0655102
NEW: 0. 4. 6
NEW: B0655120
NEW: 2.19
System (1)
Copy (2)
Engine (3)
B140S909.WMF
PC Card -> NEW Page 01
Exit (0)
ROM: B0655102
ROM: 0.4.6
ROM: B0655102
ROM: 0. 4. 6
ROM: B0655120
ROM: 2.19
NEW: B0655102
NEW: 0.4.6
NEW: B0655102
NEW: 0. 4. 6
NEW: B0655120
NEW: 2.19
System (1)
Copy (2)
Engine (3)
Update (#)Verify (./*)
B140S910.WMF

Ricoh 4051 Specifications

General

Brand	Ricoh
Model	4051
Category	All in One Printer
Language	English