STAPLER
SM 37 B468/B469/B674
3000-Sheet
Finisher
B468/B469/
B674
2.8.2 STAPLER MOVEMENT
The stapler performs horizontal and rotational movement in each of the four staple
modes.
Horizontal Stapler Movement
The stapler movement motor [A] drives the timing belt [B] which moves stapler [C]
left and right on a support bar [D].
When the Start key is pressed, the jogger fences move to the wait position 10 mm
wider than the selected paper size, the stapler motor switches on and moves the
stapler to the staple position and then switches off. The motor switches on and off
for the time needed to position the stapler for the paper size selected for the job.
If the stack is to be stapled at two locations, the stapler moves to the front position
first, staples, moves to the back position, staples, and then returns to the home
position.
NOTE: SP6120 001~011 (Staple Jogger Adjustment). Use this SP to fine adjust
the staple unit jogger fences for different paper sizes. For details, see
section “5. Service Tables”.
B468D016.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
Need help?
General
