SERVICE PROGRAM MODE TABLES
SM 5-29 B064 Series/B140 Series/G126
Service
Tables
5.6 SERVICE PROGRAM MODE TABLES
5.6.1 SERVICE TABLE KEY
Notation What it means
(B064 only)
This is added to the title of an SP that is for the B064/B065 only.
*1
(B140 only)
This is added to the title of an SP that is for the
B140/B141/B142/B143/B163/B228 only.
*1
[range/step] Example: [–9~+9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
Note: The default setting for each SP mode is shown on the screen
in the “Initial” box immediately below the entry box. Some of the
default settings for the B064 Series and B140 Series are slightly
different, so be sure to check the “Initial” box on the SP mode
screen.
Italics Comments added for reference.
*
An asterisk marks the SP’s that are reset to their factory default
settings after an NVRAM reset.
DFU Denotes “Design or Factory Use”. Do not change this value.
Japan only The feature or item is for Japan only. Do not change this value.
SEF Short Edge Feed
LEF Long Edge Feed
*1: SP titles without “B064 only” or “B140 only” are for the B064 and the B140
series machines.
To Next Page
Loading...
Need help?
General
