1A-52 Engine General Information and Diagnosis:
P0115-H (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Remove the left side cowling. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-6).
3) Check the ECT sensor coupler (1) for loose or poor
contacts.
If OK, then check the ECT sensor lead wire continuity.
4) Disconnect the ECT sensor coupler.
5) Disconnect the ECM coupler. Refer to “ECM Removal
and Installation” in Section 1C (Page 1C-1).
6) Insert the needle pointed probes to the lead wire coupler.
7) Check the continuity between the B/Bl wire and terminal
“32”. Also, check the continuity between the B/Br wire
and terminal “35”.
Special tool
(A): 09900–25008 (Multi circuit tester set)
(B): 09900–25009 (Needle-point probe set)
Tester knob indication
Continuity test ( )
ECM couplers (Harness side)
Is the continuity OK?
Go to Step 2. B/Bl or B/Br wire open.
1
I947H1110115-01
(Black)
(Gray)
?
(A)
“32”
“35”
(B)
I837H1110030-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
