Engine Lubrication System: 1E-7
• Push in the oil pressure regulator (4) to the oil pump
as shown.
• Install new gasket (5).
CAUTION
!
Use new gasket to prevent oil leakage.
• Apply thread lock to the plate bolts “A”.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER “1322” or
equivalent)
• Tighten the oil pan bolts and plate bolts diagonally to
the specified torque.
Tightening torque
Oil pan bolt: 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
Oil Pressure Regulator / Oil Strainer Inspection
B947H11506004
Refer to “Oil Pan / Oil Pressure Regulator / Oil Strainer
Removal and Installation” (Page 1E-6).
Oil Pressure Regulator
Inspect the operation of the oil pressure regulator by
pushing the piston with a proper bar.
If the piston does not operate smoothly, replace the oil
pressure regulator with a new one.
Oil Strainer
Clean the oil strainer if necessary.
Inspect the oil strainer body for damage. If necessary,
replace it with a new one.
Oil Cooler / Oil Cooler Hose Inspection and
Cleaning
B947H11506005
Refer to “Exterior Parts Removal and Installation” in
Section 9D (Page 9D-6).
Oil Cooler Hose Inspection
Inspect the oil cooler hoses for any damage and oil
leakage. If any defects are found, replace the oil cooler
hose with a new one.
3
4
I947H1150010-01
5
I947H1150011-01
“A”
I947H1150012-02
I947H1150013-02
I947H1150014-01
I947H1150015-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
