1E-8 Engine Lubrication System:
Oil Cooler Inspection
1) Remove the oil cooler guard (1).
2) Inspect the oil cooler for oil leakage. If any defects
are found, replace the oil cooler with a new one. If
the fins are bent or dented, repair them by carefully
straightening them with the blade of a small
screwdriver.
3) Reinstall the removed parts.
Oil Cooler Cleaning
1) Remove the oil cooler guard (1).
2) Remove the oil cooler mounting bolts.
3) Blow out any foreign matter that is stuck in the oil
cooler fins using compressed air.
CAUTION
!
• Make sure not to bend the fins when using
compressed air.
• If compressed air is applied from the front
side, dirt will be forced into the pores of oil
cooler.
4) Reinstall the removed parts.
Oil Cooler / Oil Cooler Hose Removal and
Installation
B947H11506006
Removal
1) Remove the side cowlings. Refer to “Exterior Parts
Removal and Installation” in Section 9D (Page 9D-
6).
2) Drain engine oil. Refer to “Engine Oil and Filter
Replacement” in Section 0B (Page 0B-10).
3) Remove the oil hoses (1) and (2).
4) Remove the oil cooler (3).
1
I947H1150037-02
I947H1150038-01
1
I947H1150039-01
I947H1150040-01
1
2
I947H1150016-01
3
I947H1150041-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
