5B-16 Manual Transmission:
Gearshift Lever Height Inspection and
Adjustment
B947H15206011
Inspect and adjust the gearshift lever height in the
following procedures:
1) Inspect the gearshift lever height “a” between the
lever top and footrest.
Adjust the gearshift lever height if necessary.
Gearshift lever height “a”
Standard: 65 – 75 mm (2.6 – 3.0 in)
2) Loosen the lock-nuts (1).
3) Turn the gearshift link rod (2) until the gearshift lever
is 65 – 75 mm (2.6 – 3.0 in) below the top of the
footrest.
4) Tighten the lock-nuts securely.
Gearshift Shaft / Gearshift Cam Plate Components
B947H15206012
“a”
I947H1520001-01
1
2
I947H1520002-01
1
2
3
4
(c)
(a)
(c)
(b)
FWD
I947H1520073-01
1. Gearshift shaft : 19 N⋅m (1.9 kgf-m, 13.5 lbf-ft) : Apply thread lock to the thread part.
2. Gearshift cam drive plate : 13 N⋅m (1.3 kgf-m, 9.5 lbf-ft) : Apply thread lock to the thread part.
3. Gearshift cam plate : 8.5 N⋅m (0.85 kgf-m, 6.0 lbf-ft) : Apply engine oil to bearing.
4. Gearshift cam stopper : Apply grease to oil seal lip. : Do not reuse.
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
