Engine Cooling System: 1F-10
3) First check the insulation between “A” and “B”
terminals with tester. Then apply 12 volts to “C” and
“D” terminals, (+) to “C” and (–) to “D”, and check the
continuity between “A” and “B”.
If there is no continuity, replace it with a new one.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication set
Continuity test ( )
4) Reinstall the removed parts.
ECT Sensor Removal and Installation
B947H11606011
Refer to “ECT Sensor Removal and Installation” in
Section 1C (Page 1C-4).
ECT Sensor Inspection
B947H11606012
Refer to “ECT Sensor Inspection” in Section 1C
(Page 1C-4).
Thermostat Removal and Installation
B947H11606013
Removal
1) Drain a small amount of engine coolant. Refer to
“Cooling System Inspection” in Section 0B
(Page 0B-12).
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation” in Section 1G (Page 1G-
9).
3) Remove the thermostat cover (1).
4) Remove the thermostat (2).
Installation
Install the thermostat in the reverse order of removal.
Pay attention to the following points:
• Install the thermostat.
NOTE
Air bleeder hole “A” of the thermostat faces
upside.
• Tighten the thermostat cover bolts to the specified
torque.
Tightening torque
Thermostat cover bolt (a): 10 N·m (1.0 kgf-m, 7.0
lbf-ft)
• Pour engine coolant and bleed air from the cooling
circuit. Refer to “Cooling System Inspection” in
Section 0B (Page 0B-12).
“A”
“B”
“C”
“D”
I718H1160006-03
1
I947H1160020-02
2
I947H1160021-02
“A”
I947H1160022-02
(a)
I947H1160023-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
