1D-24 Engine Mechanical:
Engine Assembly Installation
B947H11406018
Install the engine in the reverse order of engine removal.
Pay attention to the following points:
• Before installing the engine, install the collars (1).
• Before installing the engine, install the engine
mounting thrust adjusters (2).
• Gradually raise the rear side of the engine assembly,
and then put the drive chain on the driveshaft.
CAUTION
!
Be careful not to catch the wiring harness
between the frame and the engine.
• Install all engine mounting bolts and tighten them
temporarily.
• Tighten the engine mounting thrust adjusters (2) to the
specified torque.
Tightening torque
Engine mounting thrust adjuster (a): 23 N·m (2.3
kgf-m, 16.5 lbf-ft)
• Tighten the engine mounting thrust adjuster lock-nuts
(3) to the specified torque with the special tool.
Tightening torque
Engine mounting thrust adjuster lock-nut (b): 45
N·m (4.5 kgf-m, 32.5 lbf-ft)
Special tool
(A): 09940–14990 (Engine mounting adjust
wrench)
1
I947H1140282-01
2
I947H1140283-01
I947H1140284-01
(a)
2
I947H1140285-02
(a)
2
I947H1140286-02
(A)
(b)
3
I947H1140287-02
(A)
(b)
3
I947H1140288-02
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
