Starting System: 1I-12
Starter Button Inspection
B947H11906011
Inspect the starter button in the following procedures:
1) Remove the air cleaner box. Refer to “Air Cleaner
Box Removal and Installation” in Section 1D
(Page 1D-7).
2) Disconnect the right handlebar switch coupler (1).
3) Inspect the starter button for continuity with the
tester.
If any abnormality is found, replace the right handle
switch assembly with a new one. Refer to
“Handlebar Removal and Installation” in Section 6B
(Page 6B-2).
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the starter button inspection, reinstall
the removed parts.
Specifications
Service Data
B947H11907001
Electrical
Unit: mm
Tightening Torque Specifications
B947H11907002
NOTE
The specified tightening torque is described in the following.
“Starter Motor Components” (Page 1I-3)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-9).
1
I947H1190029-01
Position
Color
PUSH
O/W Y/G O/R
Y/W
I815H1190019-01
Item Specification Note
Starter motor brush length
Standard 7.0 (0.28)
Limit 3.5 (0.14)
Starter relay resistance 3 – 6 Ω
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Starter motor housing bolt 5 0.5 3.5 )(Page 1I-5)
Starter clutch bolt 54 5.4 39.0 )(Page 1I-11)
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
