Exterior Parts: 9D-9
Installation
Install side cowling in the reverse order of removal.
Pay attention to the following points:
• When installing the right side cowling, make sure that
the fuel tank drain hose and breather hose are routed
properly. Refer to “Fuel Tank Drain Hose and Breather
Hose Routing Diagram” in Section 1G (Page 1G-3).
• When installing the bracket, set the punch mark “A” to
the front and upper side.
Inner Under Cowling
Removal
NOTE
The left and right inner under cowlings are
installed symmetrically and therefore the
removal/installation procedure for one side is
the same as that for the other side.
1) Remove the side cowling.
2) Remove the inner under cowling (1).
Installation
Install the inner under cowling in the reverse order of
removal.
Body Cowling
Removal
1) Remove the body cowling cover.
2) Remove the left and right side cowlings.
3) Remove the inner under cowlings.
4) Remove the rear view mirror.
5) Remove the windscreen.
6) Remove the combination meter. Refer to
“Combination Meter Removal and Installation” in
Section 9C (Page 9C-2).
7) Disconnect the turn signal lead wire couplers (1).
8) Disconnect the steering damper lead wire coupler
(2).
9) Disconnect the lead wire couplers (3).
10) Remove the air intake pipe bolts.
11) Remove the screws.
“A”
I947H1940035-01
1
I947H1940022-02
1
I947H1940023-01
2
I947H1940034-01
3
I947H1940024-01
I947H1940025-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
