1E-14 Engine Lubrication System:
Oil Pump Inspection
B947H11506012
Inspect the oil pump in the following procedures:
1) Remove the oil pump. Refer to “Oil Pump Removal
and Installation” (Page 1E-12).
2) Rotate the oil pump by hand and check that it moves
smoothly. If it does not move smoothly, replace the
oil pump assembly.
CAUTION
!
Do not attempt to disassemble the oil pump.
The oil pump is available only as an
assembly.
3) Install the oil pump. Refer to “Oil Pump Removal and
Installation” (Page 1E-12).
Oil Pump Drive Sprocket Removal and
Installation
B947H11506013
Refer to “Engine Bottom Side Disassembly” in Section
1D (Page 1D-49) and “Engine Bottom Side Assembly” in
Section 1D (Page 1D-56).
Specifications
Service Data
B947H11507001
Oil Pump
Oil
Tightening Torque Specifications
B947H11507002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-9).
I947H1150035-01
Item Standard Limit
Oil pressure (at 60 °C, 140 °F)
100 – 400 kPa (1.0 – 4.0 kgf/cm
2
, 14 – 57 psi)
at 3 000 r/min
—
Item Specification Note
Engine oil type SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Engine oil capacity
Change 2 800 ml (3.0/2.5 US/lmp qt)
Filter change 3 300 ml (3.5/2.9 US/lmp qt)
Overhaul 3 600 ml (3.8/3.2 US/lmp qt)
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Oil pan bolt 10 1.0 7.0 )(Page 1E-7)
Oil pressure switch 14 1.4 10.0 )(Page 1E-10)
Oil pressure switch lead wire screw 1.5 0.15 1.1 )(Page 1E-10)
Piston cooling oil jet bolt 10 1.0 7.0 )(Page 1E-11)
Oil pump mounting bolt 10 1.0 7.0 )(Page 1E-13)
Oil pump driven sprocket bolt 10 1.0 7.0 )(Page 1E-13)
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
