1A-58 Engine General Information and Diagnosis:
P0110-L (Use of SDS)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation” in Section 1G (Page 1G-9).
3) Move the air cleaner box upward. Refer to “Air Cleaner
Box Removal and Installation” in Section 1D (Page 1D-
7).
4) Check the IAT sensor coupler (1) for loose or poor
contacts.
If OK, then check the IAT sensor lead wire continuity.
5) Disconnect the IAT sensor coupler.
6) Check the continuity between the Dg wire and ground. If
the sound is not heard from the tester, the circuit
condition is OK.
Special tool
(A): 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity test ( )
7) Connect the IAT sensor coupler.
8) Turn the ignition switch ON.
9) Insert the needle pointed probes to the lead wire coupler.
Go to Step 2. • Dg wire shorted to
ground.
• If wire is OK, go to
Step 2.
1
I947H1110028-01
(A)
I823H1110042-03
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
