Fuel System: 1G-5
Repair Instructions
Fuel Pressure Inspection
B947H11706001
WARNING
!
• Keep away from fire or spark.
• Spilled gasoline should be wiped off
immediately.
• Work in a well-ventilated area.
Inspect the fuel pressure in the following procedures:
1) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation” (Page 1G-9).
2) Place a rag under the fuel feed hose (1) and remove
the fuel feed hose.
3) Install the special tools between the fuel pump and
fuel delivery pipe.
Special tool
(A): 09940–40211 (Fuel pressure gauge
adapter)
(B): 09940–40220 (Fuel pressure gauge
attachment)
(C): 09915–77331 (Oil pressure gauge (1000
kPa))
(D): 09915–74521 (Adapter hose)
4) Turn the ignition ON and check for fuel pressure.
Fuel pressure
Approx. 300 kPa (3.0 kgf/cm
2
, 43 psi)
If the fuel pressure is lower than the specification,
check for the followings:
• Fuel hose leakage
• Clogged fuel filter
• Pressure regulator
• Fuel pump
If the fuel pressure is higher than the specification,
check for the followings:
• Fuel pump
• Pressure regulator
5) Remove the special tools.
WARNING
!
Before removing the special tools, turn the
ignition switch OFF and release the fuel
pressure slowly.
6) Reinstall the fuel tank. Refer to “Fuel Tank Removal
and Installation” (Page 1G-9).
NOTE
Connect the fuel feed hose to the fuel pump
until it locks securely (a click is heard).
1
I947H1170001-01
(A)
(C)
(D)
(B)
I947H1170021-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
