1K-11 Exhaust System:
Step 4
1) Click “Full opened” (1).
2) Measure the EXCVA position sensor output voltage
at EXCV fully opened position.
Special tool
(A): 09900–25008 (Multi circuit tester set)
(B): 09900–25009 (Needle-point probe set)
EXCVA position sensor out put voltage
EXCV is fully opened: 3.6 ≤ Output voltage ≤ 4.55
V ((+) Y – (–) W)
3) If the measured voltage is more than specification,
adjust the No. 2 cable adjuster (2) as follows:
a) Set the EXCVA to the adjustment position. Refer
to “EXCV Cable Removal and Installation”
(Page 1K-6).
CAUTION
!
Adjusting the No. 2 cable with the EXCV fully
opened can damage the EXCVA. Be sure to
adjust the No. 2 cable with the EXCV set in
adjustment position.
b) Turn out the No. 2 cable adjuster (2) in or out to
set the output voltage within the specified value.
4) After adjusting the EXCV cables, perform Step 2 to
confirm DTC “46” is not indicated.
Muffler / Muffler Chamber / Exhaust Pipe
Removal and Installation
B947H11B06008
Removal
1) Loosen the muffler connecting bolts (1).
2) Remove the mufflers (2) by removing the mounting
bolt and nut (3).
NOTE
Support the muffler to prevent it from falling.
1
I947H11B0023-02
(A)
(B)
I947H11B0024-02
2
I947H11B0025-02
1
2
3
I947H11B0027-01
1
2
3
I947H11B0026-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
