5B-20 Manual Transmission:
• Install a new snap ring (9).
Special tool
: 09900–06107 (Snap ring remover (Open
type))
• After installing the gearshift lever, check the gearshift
lever height. Refer to “Gearshift Lever Height
Inspection and Adjustment” (Page 5B-16).
Gearshift Linkage Inspection
B947H15206015
Refer to “Gearshift Shaft / Gearshift Cam Plate Removal
and Installation” (Page 5B-17).
Gearshift Shaft
Check the gearshift shaft for bend or wear.
Check the return spring for damage or fatigue.
If any defects are found, replace the defective part(-s).
Gearshift Shaft Oil Seal
Inspect the gearshift shaft oil seal lip for damage or
wear. If any defect is found, replace the oil seal with a
new one.
Gearshift Shaft Bearing
Inspect the gearshift shaft bearings for abnormal noise
and smooth rotation. Replace the bearing if there is
anything unusual.
Gearshift Shaft Oil Seal / Bearing Removal and
Installation
B947H15206016
Removal
1) Remove the gearshift shaft. Refer to “Gearshift Shaft
/ Gearshift Cam Plate Removal and Installation”
(Page 5B-17).
2) Remove the gearshift shaft oil seal (1).
3) Remove the bearings (2) and (3) with the special
tools.
Special tool
(A): 09921–20210 (Bearing remover (12
mm))
(B): 09930–30104 (Rotor remover sliding
shaft)
9
I947H1520014-01
I947H1520015-01
I947H1520016-02
I947H1520017-01
1
I947H1520018-01
(A)
(A)
(B)
(B)
2
3
I947H1520019-01
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
email: info@motomatrix.co.uk / www.motomatrix.co.uk
To Next Page
Loading...
Need help?
General
